Holiday Armor Kit for Poseable 6 Inch Action Figure: Snap-On Winter Suit, Stocking Cap, Gift Sack and Mini Sled

A snap-on winter suit with a faceted fur-trim look, a stocking cap with a pom-pom tail, a gift sack, a mini sled the figure can sit on, and two small gift boxes. Every piece snaps or slides on without glue, and all of it prints without supports.

Requires the base figure, sold separately: Poseable 6 Inch Action Figure (https://www.saiyanprints.com/products/poseable-action-figure). This kit does not include the figure.

Works on the stock figure straight out of the zip: the kit includes two grip-hole hands and the slotted chest. They swap in for the stock hands and chest on the same joints, and the hand-held sack and the back sack (without the coat) need them.

Parts (16 part files, 20 printed pieces, STL and 3MF for each, plus 3 ready-made plates):

• Winter coat shell x1 (vest-style, drops over the shoulders like the armor chest pieces)
• Belt with buckle x1
• Sleeve cuff x2, leg cuff x2, boot shaft x2
• Over-shoe, left and right
• Stocking cap x1 and cap tail with pom-pom x1
• Gift sack, hand-held (3.0 mm handle) x1
• Gift sack, back-mounted (slider) x1
• Mini sled x1 and gift boxes x2 (cube and tall)
• Grip-hole hand x2 and slotted chest x1 (swap in for the stock hands and chest)

Assembly and fit:

• Print one leg cuff first (about 3 min) and clip it onto the shin. It should click on and turn with light drag. If it's very tight or cracks, print the suit clips in PETG.
• Swap in the grip-hole hands and the slotted chest first: same neck, shoulder, waist and wrist joints as the stock parts. Have Accessory Pack Vol. 1 too? It includes the same chest and hands, so print that plate once. Own an armor kit? You already have grip-hole hands and can skip printing them, but you still need the slotted chest.
• The coat drops over the shoulders, the belt slides over the hips, the cuffs and boot shafts snap sideways onto the limbs, and the over-shoes slide on from the inside of each foot.
• The back sack slides into the coat's back slots, or straight into the slotted chest without the coat.
• The hand-held sack's 3.0 mm handle goes through a grip-hole hand.
• The stock figure sits on the sled with the back sack off. Kneeling on the sled needs the double-hinge legs from the Hands and Joints Upgrade (sold separately).
• The cap limits head side tilt to about 35 degrees, and the over-shoes limit inward leg moves. Stand the figure with the feet slightly apart.
• Includes GUIDE.pdf / GUIDE.md (settings, print order, assembly, pose limits) and a spec sheet.

CAD-checked: fits, poses and sled seating were checked in CAD against the figure's own meshes. Grams and times are slicer estimates.

Warning: small parts, choking hazard. Not for children under 3. Adult supervision recommended.

Private use only unless you buy the Commercial Use license.